- This topic has 1 reply, 2 voices, and was last updated 7 years, 5 months ago by
.
-
Posts
-
- Offline
What steps would I use to calibrate CG247x and then upload a 3D LUT into the monitor? I know DisplayCAL can’t upload LUT’s. So will I need to use ColorNavigator or other software?
Just googling “displaycal lut3d cg247x”
+
https://www.eizoglobal.com/support/db/files/manuals/03V24936H1/UM-03V24936H1-EN.pdf
+
“DisplayCAL-3DLUT-maker.exe”, 3DLUT format “.3dl” and destination profile a profile you made with DisplayCAL with your desied level of accuracy and patches.
Keep in mind that since DisplayCAL cannot use CG colorimeter you’ll need an external measurement device.
-i1Pro2 spectrophotometers with 10nm readings cannot see properly W-LED PFS phosphort backlights due to the narrow spikes in red.
-Colorimeters like i1DisplayPro need a correction (matrix or spectral). If you wish to use an spectral correction suitable for CG247x you can use the one provided in HP Z32x calibration software or the one provided with Lightspace (one of the Lightspace representatives uploaded them in LGG forum, free to download if registered). It is the same file, and its called “HP_DreamColor_Z24x_NewPanel”. It’s and EDR you’ll need to use ArgyllCMS oeminst to converto to text CCSS file that DisplayCAL uses. Choose the source if that EDR that you line most.Calibrite Display Pro HL on Amazon
Disclosure: As an Amazon Associate I earn from qualifying purchases.
