-
I am sure this will have been asked before, but what is the best way to verify your self created colorimeter correction is good? I was hoping for a simple of taking a series of readings with the colorimeter (with the newly created correction) and then take the same measurements with the Spectro, and then compare the results, if the correction is good the comparison should be within instrument repeatability . Or is it just a matter of doing a small testchar? I was kinda hoping there would be something more slick 🙂
I am sure this will have been asked before, but what is the best way to verify your self created colorimeter correction is good?
The correction self check error (delta E 2000) is shown after creation. You can also do a profile with your corrected colorimeter and then verify the profile with the spectrometer.
Thank you, the error check after the profile creation is absolutely spot on.
Display Calibration and Characterization powered by ArgyllCMS