Some one Could Verify things i did, so that everything i did was correct
My Step Up is to Calibrate TV for Media Consuming
Using MPC + Madvr
Using DisplayCAL to Generate Calibration Lut load in MadVR using I1display Pro Calibrator.
Calibrating 8bit LCD TV
So I Connected my Laptop To Tv.
My Tv Doesn’t Support Full range Output- As far as i know Because there is no way to change the Black Level of Tv
Q:Is there a way to Find Find TV output Level
I found that by Connecting Pattern Generator (Rpi Pgenerator) sending clean signal to Display unable to Blacks black 16 and Below.
But Could someone Verify is that right way of finding
Assuming that my Display is Limited i set Gpu to Full range and MadVR to Limited Range then Using Plunge Pattern i set the Contrast and Brightness
Then i opened DisplayCAL Used MadVR as Pattern Generator Rec709,BT1886 i did Calibration.
So Here are Some Questions:
Even though DisplayCAL generated 3dLut it also Created ICM along side using that ICM and Ran a verification with Rec709. Is it the right way of verifying the created lut ???
Madvr to Limited Range and Gpu to Full Range = Limited Ranged for Tv..is this right???
Or I am Totally Messed Everything
Someone Please Explain i am new to These Calibration stuffs..
-
This topic was modified 2 years, 5 months ago by Zrotufify.