-
I don’t know how to proceed with this…
If I adjust RGB controls on the monitor for Whitepoint, thhen adjust again for Balckpoint, the Whitepoint adjustment of course gets modified.
I don’t know what I’m doing… please advice. Thanks
=============
Or do I reset the monitor and just adjust “Brightness” under Blackpoint and “Contrast” under Whitepoint and not touch RGB gains then proceed with Calibration?
Attachments:
You must be
logged in to view attached files.
RGB gains for white
RGB offset for little tweak on black point
check white
RGB offset for little tweak on white point
If you need to choose, surrender black point. Also your back point seems +- ok for a common IPS.
RGB gains for white
RGB offset for little tweak on black point
check white
RGB offset for little tweak on white point
If you need to choose, surrender black point. Also your back point seems +- ok for a common IPS.
Do I adjust the contrast too to bring the bar to the middle? Thanks
Why?
I would not care even about brightness. Set native/as neasured to both, then when adjusting RGB gains for white set whatever brightness you want. Taht popup will measure it, so you have feedback even if you did not set a brightness target.
Display Calibration and Characterization powered by ArgyllCMS