Mode selection

[KenF]

I was helping someone to install and run DisplayCal. He has an i1Display Pro. I have a Spyder 5. 

When I first set up DisplayCal, I imported the corrections from my Datacolor software as the instructions suggest. I had him do the same with i1Profiler.

On my computer, I get the following Mode options:

• Refresh (generic)
• LCD (generic)
• LCD CCFL
• LCD CCFL Wide Gamut
• LCD White LED
• LCD RGB LED
• LCD CCFL Type  2

However, when he looks at the Mode options, he only sees:

• Refresh (generic)
• LCD (generic)

Is this correct? I thought these options were consistent across devices and the corrections were there to create a better match of the sensor with the display type.

If he should only see two then that is fine, but my question would be where can I find documentation on what devices will see?

Thank you!

Calibrite Display Pro HL on Amazon  
Disclosure: As an Amazon Associate I earn from qualifying purchases.

[Vincent]

Modes is a extremely limited selection for Spyders (all of them).
i1Displaypro users do not use modes, they use spectral corrections CCSS under “correction” combo:
http://displaycal.net/i1d3

[KenF]

Okay, thanks. I figured it was this but I wanted to verify.  I appreciate the help.

[Author]

Posts