Hello
Is it normal, that the last five values are viewed in a test picture in the same gray (white/black) values?
So after the calibration the values 0 to 5 and 250 to 255 are shown in the same graytone.
For me it seems, that it is not correct calibrated. Or might it be, that my Prolite T2451MTS is that bad?
Can I do anything, that the lowest 5 darks and highest 5 lights can be seen as different values, resp. better be calibrated?
I do not know, what the fault is…
However, as I know, minimum the complete grayscale should be seen correctly after a calibration, and should not cut everything below 5 and above 250.
Thank you.