How do I check pre-calibrated data?

[Bijan Jamshidi]

Hello,

I just downloaded this software yesterday and have figured out a lot of stuff after a lot of research. However one thing I can’t figure out is how to check my sRGB, Adobe RGB and P3 covered gamut as well as my DeltaE’s pre-calibrated so I can compared it to a calibrated display. Is this possible? If so, where can I find it?

Thank you!

[Vincent]

Change OSD to the one you need to verify. In verification tab, check & choose simulation profile you want to test against to, check “use simulation profile as display profile” (clean current GPU calibration and test if direct GPU-display output matches selected colospace). Then run measurement report.

If verify is disabled you may need to install in File menu factory ICC profile. Since you’ll going to verify factory calibration with “use simulatin as displayprfile”) it is not an issue. Otherwise for color managed apps OSD mode and default dislay profile in OSD must match, no matter if relying on standard profiles or custom ones.

• This reply was modified 6 years ago by Vincent.
• This reply was modified 6 years ago by Vincent.

[Author]

Posts