Does DisplayCal support Eizo HW calibration?

Home Forums General Discussion Does DisplayCal support Eizo HW calibration?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #32547

    memoriaphoto
    Participant
    • Offline

    I have an Eizo which I use ColorNavigator to “hardware calibrate”. Earlier I have used DisplayCal for my non-hardware calibration monitors. Can I use DisplayCal for my Eizo or is ColorNavigator needed to communicate and upload LUTs to the monitor?

    #32548

    Vincent
    Participant
    • Offline

    You need to use ColorNavigator (CN) to write HW cal, or maybe Calman/Lightspace in CG-X models.
    You can use DisplayCAL to make a more accurate profile without calibrating grey in GPU, if you need it (CN matrix 1TRC should be accurate enough)
    You can use DisplayCAL  to verify HW cal from CN and check if it is using the proper EDR for i1d3 (if you use an i1d3)

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Log in or Register

Display Calibration and Characterization powered by ArgyllCMS