Brightness after calibration and Printer calibration

[titorai]

Hello, new to this forum so please forgive if this is a repeated question!

I just got a Spyder 5 calibrator with SpyderPrint and ran came across DisplayCal after doing some searching around because I was little disappointed with the Datacolor results. After the DisplayCal calibration my monitor is definitely brighter than DataColor results and the print does not match. I was wondering if I missed a DisplayCal setting somewhere or should I try again?

Also, is there a way to calibrate the printer to match DisplayCal calibration?

Thanks for any suggestions.

[Florian Höch]

Hi,

print evaluation definitely requires careful environmental setup. The brightness of the monitor (and whitepoint) should roughly match that of the viewing illumination. Also, the printer needs to be accurately profiled.

[Author]

Posts