About white level setting?

[dnnso]

Dear everyone,

May I correct in just changing the white level to custom and changing the value there to want, eg 150cd/m2?
And if can be modify, except can set from the DisplayCAL interface.
on the other hand, If I want to change from the program. Can you tell me where to change the white level value or read the white level value?

[Florian Höch]

Hi,

May I correct in just changing the white level to custom and changing the value there to want, eg 150cd/m2?

Yes, you can do that. Although note that the goal is usually not to aim for an arbitrary monitor luminance, but to control your environmental lighting and then adjust the monitor so it is neither too dim nor too bright for the environment. Then, after you have established a brightness setting, use “As measured” in DisplayCAL. In a typical home/office environment (during the day), monitor luminance that allows comfortable work usually falls roughly in the 120-160 cd/m2 range.

[dnnso]

Thanks for reply.

On the other hand, I would like to ask if I want to change from the program. Can you tell me where to change the white level value or read the white level value?

[Florian Höch]

Can you tell me where to change the white level value or read the white level value?

You can read the white level (in cd/m2) during interactive display adjustment.

[Author]

Posts