A "clean" monitor characterization?

Home Forums General Discussion A "clean" monitor characterization?

This topic contains 15 replies, has 3 voices, and was last updated by  Alex Sikorsky 2 months, 1 week ago.

Viewing 16 post (of 16 total)
  • Author
    Posts
  • #16366

    Alex Sikorsky
    Participant
    • Offline

    On the measurement does not affect

    … This can be different from using the current videoLUT contents (current videoLUT contents are likely those of the profile you installed last if you haven’t changed them deliberately). To use current videoLUT contents, you have to select “<current>” under settings.

    When I calibrate display again , I will check this important factor. I would add it to the calibration page help. – It is not enough to install everywhere “as measured”, you need to load the previous calibration into the settings.

Viewing 16 post (of 16 total)

You must be logged in to reply to this topic.

Log in or Register

Display Calibration and Characterization powered by ArgyllCMS