#7830 (Bug) Creating a profile from management data = correction changes to “none”

+1 0

Closed as Not A Bug
Component: DisplayCAL
Created by benjamin

Last modified

Hi Florian,

My aim was to make a single curve + matrix from an existing xyz lut + matrix profile, and keep all other settings intact.  I did this by using the “Create profile from measurement data”.  The new single curve + matrix profile was made, a success.

However, when the new profile was made, i found that, the monitor correction, changed from “Spectral Lcd White Led Ips”. to “none”

Is this supposed to happen?

Cheers, Ben.

2 comments on “Creating a profile from management data = correction changes to “none””

  1. Hi,

    However, when the new profile was made, i found that, the monitor correction, changed from “Spectral Lcd White Led Ips”. to “none”

    It depends where you save the profile. If you save it to the same folder as the existing profile, the correction will already be there.

  2. Ah, that makes sense.  I’ll just save it to the same folder as before.  For some reason I must of thought the correction info was baked into the icm file!  Which it obviously isn’t.

    Thank you!

Comments are closed.