-
Hi
In Ubuntu 14.04 with dispcalGUI 3.0.3.1 with Argyll 1.6.3 and Hugski calibration device, when I start calibration, it displays a window for Interactive setup of display and when I click on Start measure it displays few color blocks and then get stuck on white and beep everything second. Whatever I play with color settings of display the value displayed in calibration window don’t change 🙁
Any ideas what’s wrong ?
Thanks
-
This topic was modified on 2015-07-21 15:47:07 by vincen_pujol.
Hi,
it beeps each time a reading is taken. For the ColorHug, I would recommend to not do any whitepoint adjustment though, it’s not accurate enough on a lot of displays without a custom-made colorimeter correction (this is a known shortcoming of the ColorHug hardware). Cancel the calibration, then set measurement mode to “Auto” and reset the display to factory defaults. Then start the process again.
Display Calibration and Characterization powered by ArgyllCMS