- This topic has 1 reply, 2 voices, and was last updated 5 years, 5 months ago by
.
-
Posts
-
Hi,
Should I set for calibration process (BMD video I/o, monitor via HDMI) Data Levels in Video Monitoring to full or video? And should I leave LUT’s settings and full range or set video? By default? I got strange issues with calibration LUTs at the moment
best!
Tomasz
Hi,
Should I set for calibration process (BMD video I/o, monitor via HDMI) Data Levels in Video Monitoring to full or video?
Video or “auto” (the latter is recommended). Note that you will probably instantly notice when this is set incorrectly, because the signal will either clip (loosing detail near black and white) or be compressed (resulting in raised black floor and reduced peak white).
And should I leave LUT’s settings and full range or set video?
For Resolve 3D LUTs, always use full range. Output level scaling is done by Resolve internally.
