How do I build the best test matrix for eecolor LUT?

[RIppolito]

Florian,

I have built a 3D LUT for my eecolor, which is in front of an OLED65B6P, and the results are very good.  However, I would like your help to determine if I can build a better one.

My settings for building the test pattern matrix were as follows…

• Profile – XYZ LUT + swapped matrix
• Profile quality – high
• sequence – minimize display response delay
• 2032 samples

If I wanted to build the highest quality 3D LUT, what would you recommend I use for the above parameters?

Thank you in advance…be well

Ron

[Florian Höch]

If I wanted to build the highest quality 3D LUT, what would you recommend I use for the above parameters?

Around 1000-2000 patches is usually more than enough for a really high quality profile of an additive RGB device.

[RIppolito]

Do I have the other settings (profile and sequence) right?  I’m assuming that the sequence I used was built to take the shortest measurement time.  Is there another sequence that yields a better result, although taking more measurement time?

Ron

[Florian Höch]

You can read about patch sequence (=patch order/sorting) in the documentation.

[Author]

Posts