Hi guys.

My laptop is connected via USB C and HDMI to 2 displays.  The laptop generally sits closed on my desk.  It’s display (although not functioning being closed) is 1/3 in my set up with display 2 being my primary.  Odd I know but that’s how it is set – Windows describes it thus:

1 is on 3 and two is primary.

Now that is out of the way here comes my issue.

The 2 displays 27 inch Iiyama’s are calibrated and I assume the profile applies to these 2 Iiyama displays.  However since the laptop display is not calibrated I assume it uses the profile for the Iiyama of the 1/3.

Is there a way that I can have a profile for the laptop independent of the multi display set up so that when I use the laptop alone it uses a profile specific to the laptop display; in this case Display 1 alone without 2 or 3?

If possible how do I set that up?

My concern is that if I calibrate the laptop display with not other displays connected it will mess up Display 3 when it is because the profile for 1 will be used for 3; a different display entirely.

Hope this is easy to understand – was not easy to explain 🙂

Cheers

Alan