Advice on matching Sdi monitors in 709

[DavidG]

Hi

I´m using DisplayCAL with a i1 Display Pro to match monitors via Sdi, with good results, just wanted to check if I´m doing something wrong or I could do it better.

I normally generate a 100% White video in my Mac Pro in Assimilate Scratch and then output it through Sdi to the monitors I need to look the same. Normally my target is white 6500 or 709 chroma coordinates and 120 brightness.

Then I use my macbook pro running DisplayCAL with the i1 Display Pro, hit calibration and wait for the interactive RGB bars to show up. Then I stick the i1 to each monitor and check/change RGB settings of the monitor until RGB bars are equal, and so on for all the monitors.

Thanks!

Calibrite Display Pro HL on Amazon  
Disclosure: As an Amazon Associate I earn from qualifying purchases.

[Florian Höch]

Hi,

that sounds fine.

[Author]

Posts