White-point Calibration

[Ievgenii Larin]

Hi guys!

Thank you Florian for developing DisplayCAL.

I work in a small production/post-production facility. Last week I was testing DisplayCAL & ArgyllCMS. Typically I deal with reference monitors (mostly HD-SDI, Rec 709) without built-in LUT selection.

I’d like to calibrate white-point with a standard black to white test chart and skip profiling part. Is it possible to get just the calibration window with RGB (D65) and luminosity sliders? Command-line example is absolutely acceptable too.

Thanks!

[Florian Höch]

Hi,

I’d like to calibrate white-point with a standard black to white test chart and skip profiling part. Is it possible to get just the calibration window with RGB (D65) and luminosity sliders?

Make sure “Interactive display adjustment” is enabled on the “Calibration” tab, then start a calibration & profiling run. After adjusting the monitor, just cancel the process.

[Ievgenii Larin]

Thanks!

[Author]

Posts