Verify a monitor without creating a profile?

[Rodrigo Silvestri]

Hi. When I calibrate monitors I usually install DisplayCAL in the computer they’re connected to, and I like to start by creating a measurement report before calibrating it, but the “measurement report” button is greyed out. Is there any simple way to generate a measurement report if there is no previous DisplayCAL profile in that computer?

Thanks,

Rodrigo

[Florian Höch]

On the verification tab enable “use simulation profile as display profile” and set tone curve to “unmodified”.

[Rodrigo Silvestri]

I’m trying to do this now,  “use simulation profile as display profile” was enabled, I selected Unmodified and the Measurement report button is still greyed out…

How do I create a measurement report from scratch?

Thanks,
Rodrigo

EDIT: Disabling Device Link Profile enabled the button. Is that OK? Thanks!

• This reply was modified 4 years, 4 months ago by Rodrigo Silvestri.

Attachments:

You must be logged in to view attached files.

[Florian Höch]

Disabling Device Link Profile enabled the button. Is that OK?

Yes.

[Author]

Posts