Spectrolino, Windows 10, Instrument Access Failed

[Everyone Change]

Hi to all,

I receive an error message when attempting to calibrate external Monitor with Spectrolino on Windows 10.

Error – new_disprd failed with ‘Instrument Access Failed

Setup:

Windows 10, 64bit Laptop.

DisplayCAL 3.8.9.3, ArgyllCMS 2.1.2.

Spectrolino on Comport.

Prolific usb-comport set to com2, 9600,8,N,1,N

DisplayCAL > Options > Advanced >Skip legacy serial  is turned off.

Same  hardware works fine on a windows 7, 64bit installation with DisplayCA

No x-rite Software has been installed. The i1Display Pro works fine with the same  hardware and software. However I would like to use the Spectrolino. Please help.

• This topic was modified 3 years, 3 months ago by Everyone Change.

Calibrite Display Pro HL on Amazon  
Disclosure: As an Amazon Associate I earn from qualifying purchases.

[InterrobangMP]

Did you ever figure this out? I am getting the same error.

[Everyone Change]

I can not tell you for sure, if there ever was a solution. Currently I am using an external monitor that has hardware calibration with an i1displaypro attached to USB.

You may try loading the displaycal with  right-click >> Run as administrator

That is what I would try first in hindsight.

Kind regards

[Author]

Posts